Description Ordering Guide 16/3 GAUGE WIRE *Most common gauge Available for Ice Eaters and Decorative Lighting The Quick Disconnect Connector has an Outside Diameter of 1 1/8″ 115V / 230V Available Up to 100′ Long 14/3 GAUGE WIRE Available for Ice Eaters, F-Series, and Decorative Lighting The Quick Disconnect Connector has an Outside Diameter of 1 1/8″ Available Up to 400′ Long (12/3 Gauge Predominantly Used between May 2017 – May 2019) Install Instructions Unplug the Unit From the Power Source Loosen and Remove the Existing Power Cord Take Replacement Power Cord and Run Through the 2-1/2″ Water Intake Hole at the Bottom of the Shroud Apply a Small Pea-Sized Amount of Dielectric Grease to Power Cord Connector Line Up the Pins and Holes From the Power Cord and Connector on the End Bell, and Then Twist it on Make Sure to Hand Tighten Only – Do Not Over Tighten – Do Not Use Tools In Order to Prevent the Power Cord from Hitting the Propeller, Pull Out Additional Slack Through the 2 1/2″ Water Intake Hole and Secure with Clip and Screw One Additional measure you can take is to secure the power cord to a bracket with a zip tie and then secure with the clip and screw on the shroud. Spin the propeller by hand after you complete the install to make sure the propeller does not hit the cord.
